I was looking over my photos and was curious to know what exactly you would like to see in this assembly guide.

Currently I follow these steps per unit.

1. Preselect LED's for each "string" and put them in a breadboard so I can just grab them as I need them, not a necessary step but I still do it.
2. Start at string 1 and solder in the resistor after bending the leads.
3. Place each LED in the string in the board, make sure it lays flat, then bend leads…

This is to serve as a teaser while I compile the images I have take, two for each item soldered on so its a bit.



Also it should be noted this unit has not been tested beyond a short "pretest" of the LED's before soldering in place. I will try to get a working picture of this tomorrow when I solder on the main leads and the Jumpers for the other leads to jump to then next board.

This stated here is some goodness for you to look at. TLeft is 1, TRight is 2, BLeft is 3,…

Ok if you read my last blog post, and mainly the comments, you know I am still waiting for items to come in and I ran into a snag with the PCB hole spacing not being ideal for my ultra compact LED layout.

To review that is this layout

The problem is simple, if you place two LED's in with the anodes (positive side as indicated by the purple/pink…