Aquaponic Gardening

A Community and Forum For Aquaponic Gardeners

A practical & inexpensive tool to measure water turbidity.

 See wiki "Secchi disk"

Views: 306

Replies to This Discussion

So ... Bob  How  turbid is it?  

I didn't choose to use the calculated standard numbers.

I have been running the "Polishing" filter, and my water is clear enough now to see the disk clearly to the bottom of the FT.  At this level the Tilapia are invisible, do to the coating on the walls and bottom of the FT.

One of the reasons I constructed the disk was so people may compare results without the expensive equipment.

When the polishing filter gets saturated I will let the turbidity build up so I have a calibration of sorts.

I have extended to pole to allow up to 55 inches and by holding the pole at an angle I can still read the disk at 55 inches. So I would have a (practical)measurement of clarity of 55 or turbidity of 1/55 or 0.018

Robert, what percentage of your water goes through the 'polishing" filter? I'm going to see if I can find any of your old posts describing it,

Unless I open the bypass valve, 100 percent of the water goes through the polishing filter, after going through the media beds and the sump (300 Gallon) which allows suspension of some solids. 

Pat James said:

Robert, what percentage of your water goes through the 'polishing" filter? I'm going to see if I can find any of your old posts describing it,

interesting Bob, thanks for sharing



Robert Rowe said:

I purchased 2 filter cartridges.

Cartridge 1 saturated in 11 days at which time I rinsed it with a hose jet and soaked it in an approved cartridge cleaner.

Cartridge 2 Saturated in  7 days at which time I rinsed it with a hose jet and soaked it in an approved cartridge cleaner.

Cartridge 1 reused It appears to be saturated after less than one day. I will report when I figure it out. I suspect the chemicals didn't remove the film from the cartridge.

2014-01-23

The Saga continues: It looks like another idea gone south. Nothing I have tried has removed the thin film from the cartridge filtering surface. I am going to try some more but My conclusion looks to be steer clear of this bad idea.

RSS

© 2024   Created by Sylvia Bernstein.   Powered by

Badges  |  Report an Issue  |  Terms of Service