Aquaponic Gardening

A Community and Forum For Aquaponic Gardeners

I have a friend of mine that has a syphon set up on his grow beds and they start the vacuum process but don't stop. I've never built one. Anyone know what that problem is? Not big enough holes on bottom?

Views: 214

Reply to This

Replies to This Discussion

all you will ever want to know about bell siphone

Flow begins seal little pipe, syphone starts vacuum breaks at the bottom of pipe level by air rushing in.

If flow equals vacuum seal, syphone will not break. Decrease flow. look at the link for size matching to bed size.

there are some cheats, some are quite smart, some defeat part of the idea, of air pullen in as water pulled out.

 

Good Luck.

I just set mine up and had the same problem.I started by allowing water to enter faster and after that didn't help I slowed the amount of water entering the grow bed and then it has worked perfectly

Siphons failing to start, or stop properly... are almost always related to flow...

The affnan siphon allows for a greater range of flow... and siphon reliability...

Thanks I'll let him know!

Reply to Discussion

RSS

© 2024   Created by Sylvia Bernstein.   Powered by

Badges  |  Report an Issue  |  Terms of Service