Aquaponic Gardening

A Community and Forum For Aquaponic Gardeners

I am just starting.  I have a 100 gal tank and two grow beds made from a 55 gal drum.  How long should the cycle be?  How long should it take to fill and then empty?

Views: 138

Reply to This

Replies to This Discussion

I've heard from 10-20 minutes for each cycle.

A good rule of thumb is to pump the volume of your fish tank 1 time per hour.  This will allow enough filtration to occur to keep your water quality high. Since the volume of grow bed is 1/2 that of the fish tank it also means that your grow bed filtration will only support 1/2 the density of fish that a 1:1 ratio would.  You will not need a whole lot of fish to grow a lot of plants - something in the range of 3-8 pounds. My system has a grow bed 1/2 the size (24 Gallons) of your total and I only need 2 adult goldfish to power it or something like 1.5 pounds of fish.

Once you put the media in the 1/2 drums it should only take about 15-20 gallons to cycle both grow beds so you would need to cycle 5-7 times an hour to meet the rule of thumb guidelines of pumping the volume of your fish tank 1 time per hour. If you add another set of grow beds (which would match your fish tank) you would only need to cycle 3-4 times an hour.

until you start seeing nitrates. add some aquarium water like 4-6 gallons to speed it up.

Reply to Discussion

RSS

© 2024   Created by Sylvia Bernstein.   Powered by

Badges  |  Report an Issue  |  Terms of Service