Aquaponic Gardening

A Community and Forum For Aquaponic Gardeners

After all of the necessary holes are drilled in both PVC caps, it's now time to glue them together. It's best to sand down the edge of the inner cap in order to make a larger and flatter surface area than you would normally have with it's rounded edge. Standard PVC primer and cement procedures apply here. Apply PVC primer to both surfaces in order to soften them up and let dry for a minute, Then apply PVC cement to both surfaces and put them together. Position the inner 1.5" cap so it is centered and leave both to sit and cure for at least an hour.

Views: 241

Comment

You need to be a member of Aquaponic Gardening to add comments!

Join Aquaponic Gardening

Comment by Max Gfx on February 6, 2014 at 5:21pm

I haven't had time to add captions yet. It's the top that I use in my towers and upside down tomato planters. It's basically a shower head. The inner PVC cap fills up and then overflows out of all 8 holes.

Comment by Daniel Wilmington on February 6, 2014 at 2:05pm

is this a siphon drain or what is this used for?

© 2019   Created by Sylvia Bernstein.   Powered by

Badges  |  Report an Issue  |  Terms of Service