Comment

Comment by Rob Nash on May 27, 2012 at 8:06am

i like to grind a slope on the pipe. you could use a bench top wheel, or a cinder block like i do. then i use a piece of alovera plant for lube. works great! …this is not my work, this is a picture of the system at Nelson and Pade’s training facility. The arrow on the left is backwards, both of the separators (clarifiers) drain into the mineralization tanks in the center.

Comment by Pavel Zeman on May 10, 2012 at 2:22am

Are all these Uniseals? That must have been a lot of work to put them in.

I usually cut a little into the edge of the pipe and use a heat gun to warm up the pipe (and some liquid soap) to get it to go through.

Do you have a better way of doing it?

Comment by chuck on September 24, 2011 at 1:18pm

we r gona need a few more pic of this to get a better idea of how the water flows