Aquaponic Gardening

A Community and Forum For Aquaponic Gardeners

Is there a way to get a bell siphon to work properly with little flow? I have looked everywhere and can’t find a good solution.

Thanks!

Views: 1358

Reply to This

Replies to This Discussion

very good!, it will be about a 5` drop. I have a nice hill to deal with.....want to keep it as simple as possible, thanx

Keep in mind I have not tested the indexing valve with a FLOUT yet.  I did run some tests with the 1 1/4" gravity modified indexing valve and a barrel ponics type flush valve.  I used over size pipe from the flush tank to the valve and only reduced down right at the valve.

 

I expect to perhaps run some more gravity tests after Thanksgiving some time though I've been rather busy and haven't managed to set it up yet.

I had every intention of using over sized pipe right up to the indexing valve..for that extra ump of impact from the volume surge...too cool

Reply to Discussion

RSS

© 2020   Created by Sylvia Bernstein.   Powered by

Badges  |  Report an Issue  |  Terms of Service